equipment hire

ARP

TANGLEWOOD

MICROKORG XL

BURNS KING COBRA

CASIO CDP130

PROJECT

Alesis Elevate 6  Passive Studio Monitor with HF Trim Switch + Binding Posts (Single Speaker) Maximize

Alesis Elevate 6 Passive Studio Monitor with HF Trim Switch + Binding Posts (Single Speaker)

Warning: Last items in stock!

£129.99

The Alesis Elevate 6 Passive is a passive studio monitor (100 watts RMS) that delivers a flat frequency response, clear stereo imaging, and excellent bass transient response for professional mixing and monitoring. Equipped with a 6.5-inch woven Kevlar low-frequency driver and 1-inch natural silk dome tweeter, Elevate 6 Passive ensures sound stays accurate and clean across a wide frequency range. Its enhanced elliptical waveguides widen the sweet spot for consistent, stereo listening and enable you to make adjustments to your mix that translate perfectly to any playback system. Plus, the baffle radiuses were meticulously designed to reduce edge diffraction. The result is clean transparent sound that enables you to mix, accurately. Elevate 6 Passive also comes with an onboard HF-trim switch giving you a professional reference monitor setup that adapts to your production environment. With -2db, 0db, and 2db settings, you can quickly adjust Elevate 6 Passive to fit the acoustics of any sized room or studio, especially when it's situated close to a studio wall. Finally, a 1/4” input and 5-way binding post connect Elevate 6 passive to your favorite power amp. Technical Specs Frequency Response: 60 Hz – 20,000 Hz (+3 dB) Frequency Range: 45 Hz – 24,000 Hz (-10 dB) Crossover Frequency: 2.2,00 Hz HF Trim: +2 dB, 0 dB, -2 dB (above 3,000 Hz) Low-Frequency Driver: Magnetically shielded 6.5” woofer with a Kevlar cone and a damped linear rubber surround High-Frequency Driver: 1” silk-dome tweeter Sensitivity: 88 dB SPL (2.83 V / 1 m) Maximum Output: 108 dB SPL (continuous), 114 dB SPL (peak) Power Rating: 100 W (RMS), 200 W (peak) Recommended Amplifier Power: 50 W – 150 W (RMS) Inputs (1) 1/4” (6.35mm) TRS input, using a standard 1/4” (6.35mm) TRS cable (2) binding posts, using heavy-gauge speaker cables with a minimum gauge of 18 AWG. (You can use bare wires or banana plugs) Input Impedance: 4Ω (nominal) Polarity: Positive signal at + input produces outward LF cone displacement Dimensions (width x depth x height): 8.5” x 10.3” x 15” Weight (monitor only): 14.3 lb Box Contents (1) Elevate 6 Passive Monitor Quickstart Guide Safety & Warranty Manual

Cart  

No products

£0.00 Shipping
£0.00 Total

Cart Checkout